Characteristics of infrared radiator
Infrared radiator is composed of nickel chromium alloy electric heating wire and silicon rubber high temperature insulating cloth, superior physical properties, high strength, can withstand repeated bending without affecting the heating life and performance. At the same time, the product can be made into a variety of different shapes according to customer requirements, strong plasticity. Very good softness, so that the infrared radiator can be heated objects close contact, heating effect is good. one Product use
1) Silicone rubber heater can be used in wet, no explosive gas occasions, industrial equipment pipes, tanks and other mixing heat and heat preservation (barrel heater), when using can be directly wrapped on the surface of the object being heated.
2) As refrigeration protection and auxiliary heating of air conditioning compressor, motor and other equipment.
3) As the auxiliary heating of medical equipment (such as blood analyzer, test tube heater, health care shapewear, shapeweight belt to compensate heat, etc.).
two Product features
1) Heating quickly, its thermal conductivity of 1W/ C square meters. Because of its small heat capacity, it can be quickly turned on or off.
2) high thermal efficiency, in the case of boiling liquid, the temperature of the heating film itself is only dozens of degrees higher than the liquid, 2-3 times more energy saving than ordinary electric furnace.
3) Water resistance, acid resistance, alkali resistance, high electrical insulation strength.
4) High mechanical strength, 100kg/cm2.
5) small size, heating sheet in use almost does not occupy space.
6) easy to use, because of its own insulation, no flame, for heat preservation, heat insulation in the process is greatly simplified.
7) The temperature range is wide, from -40℃ to 200℃, which is beyond the reach of general electrical appliances.
8) Long life, under normal use conditions, can be almost permanent continuous use.
9) Can be made into any size, can rely on the temperature controller to assist the precise temperature control function.
3. Technical parameters
1) Maximum temperature resistance of insulating material: 250℃
2) Operating temperature range: -40~200℃
3) Power error: ±5%
4) Insulation resistance: ≥50 MΩ
5) Compression strength: 1500V /5s
6) Resistant voltage: > 5 kV
7) Mechanical strength: 100kg/cm2
Four. Matters needing attention
1) Infrared radiator is non-waterproof structure, so do not contact with oil, water and plastic particles during storage and installation to prevent electric leakage.
2) Before installation, check whether the installation position is consistent with the specifications of the infrared radiator and whether the voltage is consistent.
3) When installing, the electric heating plate must be closely bonded to the heated body, and the surface of the heated body should be flat and complete without uneven phenomenon.
4) after the use of electric heating plate, such as found that the surface of the charred black color, it indicates that the heat and heat body heat imbalance, should be adjusted in time to prevent burning through.
5) The finished products of infrared radiator are prohibited from bending, drilling and other modifications, otherwise it will damage the internal heating elements, and even generate electric shock, leakage and other risks.
0086-510-85522050 | +49 15908476791 | +86 13382246779 | +86 18018303926
Contact Us
Present position：